When the J784S4-EVM is configured for PCIe Boot, the Bootloaders are to
be written to the address specified by particular BARs. The existing
documentation hard-codes the address corresponding to the BAR under the
assumption that the Root-Complex transferring the Bootloaders is also
a J784S4-EVM. The Root-Complex assigns addresses to the BARs depending
on the currently available set of free system addresses. Since the free
system addresses vary with the Root-Complex being used, instead of
hard-coding the BARs, automate the process of identifying the appropriate
BAR in the form of a command to be run by the user on the Root-Complex.
Signed-off-by: Siddharth Vadapalli <s-vadapalli@ti.com>
This patch series adds support for ZFS listing and load to u-boot.
To Enable zfs ls and load commands, modify the board specific config file with
#define CONFIG_CMD_ZFS
Steps to test:
1. After applying the patch, zfs specific commands can be seen
in the boot loader prompt using
UBOOT #help
zfsload- load binary file from a ZFS file system
zfsls - list files in a directory (default /)
2. To list the files in zfs pool, device or partition, execute
zfsls <interface> <dev[:part]> [POOL/@/dir/file]
For example:
UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/
3. To read and load a file from an ZFS formatted partition to RAM, execute
zfsload <interface> <dev[:part]> [addr] [filename] [bytes]
For example:
UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage
References :
-- ZFS GRUB sources from Solaris GRUB-0.97
-- GRUB Bazaar repository
Jorgen Lundman <lundman at lundman.net> 2012.
98d1d3227e