Reading doc/board/google/chromebook_coral.rst we can see that at some
point it was intended to put the bloblist in CAR, rather than DRAM, at
some point during development. This is fine for TPL/SPL stages where we
have very minimal information stored in the bloblist and so we can set
the limit there to 4KiB and then expand it to 196KiB in U-Boot proper so
there's room for ACPI tables and so forth. We also update the
documentation to use the same location for CONFIG_BLOBLIST_ADDR in both
references.
Signed-off-by: Tom Rini <trini@konsulko.com>
This patch series adds support for ZFS listing and load to u-boot.
To Enable zfs ls and load commands, modify the board specific config file with
#define CONFIG_CMD_ZFS
Steps to test:
1. After applying the patch, zfs specific commands can be seen
in the boot loader prompt using
UBOOT #help
zfsload- load binary file from a ZFS file system
zfsls - list files in a directory (default /)
2. To list the files in zfs pool, device or partition, execute
zfsls <interface> <dev[:part]> [POOL/@/dir/file]
For example:
UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/
3. To read and load a file from an ZFS formatted partition to RAM, execute
zfsload <interface> <dev[:part]> [addr] [filename] [bytes]
For example:
UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage
References :
-- ZFS GRUB sources from Solaris GRUB-0.97
-- GRUB Bazaar repository
Jorgen Lundman <lundman at lundman.net> 2012.
5c72a2afbf