mirror of
https://source.denx.de/u-boot/u-boot.git
synced 2026-06-13 15:03:58 +03:00
c3407f4f5c
MD Danish Anwar <danishanwar@ti.com> says: The series introduces device tree and config changes and AM65x to enable ICSSG driver. The series also enables SPL_LOAD_FIT_APPLY_OVERLAY for AM65x in order to load overlay over spl. The ICSSG2 node is added in device tree overlay so that it remains in sync with linux kernel. This series has been tested on AM65x SR2.0, and the ICSSG interface is able to ping / dhcp and boot kernel using tftp in uboot. The users need to set env variables fw_storage_interface, fw_dev_part, fw_ubi_mtdpart, fw_ubi_volume to indicate which storage medium and partition they want to use to load firmware files from. By default the env fw_storage_interface=mmc and fw_dev_part=1:2 but users can modify these envs as per their requirements.
182 lines
4.9 KiB
Plaintext
182 lines
4.9 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_SKIP_LOWLEVEL_INIT=y
|
|
CONFIG_ARCH_K3=y
|
|
CONFIG_SYS_MALLOC_LEN=0x2000000
|
|
CONFIG_SYS_MALLOC_F_LEN=0x8000
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_NR_DRAM_BANKS=2
|
|
CONFIG_SOC_K3_AM654=y
|
|
CONFIG_TARGET_AM654_A53_EVM=y
|
|
CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
|
|
CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0x80480000
|
|
CONFIG_ENV_SIZE=0x20000
|
|
CONFIG_ENV_OFFSET=0x680000
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_SPL_DM_SPI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="k3-am654-base-board"
|
|
CONFIG_SPL_TEXT_BASE=0x80080000
|
|
CONFIG_OF_LIBFDT_OVERLAY=y
|
|
CONFIG_DM_RESET=y
|
|
CONFIG_SPL_MMC=y
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL_DRIVERS_MISC=y
|
|
CONFIG_SPL_STACK_R_ADDR=0x82000000
|
|
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
|
|
CONFIG_SPL_BSS_START_ADDR=0x80a00000
|
|
CONFIG_SPL_BSS_MAX_SIZE=0x80000
|
|
CONFIG_SPL_STACK_R=y
|
|
CONFIG_ENV_OFFSET_REDUND=0x6A0000
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
# CONFIG_PSCI_RESET is not set
|
|
CONFIG_PCI=y
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
|
|
CONFIG_DISTRO_DEFAULTS=y
|
|
CONFIG_OF_SYSTEM_SETUP=y
|
|
CONFIG_BOOTCOMMAND="run findfdt; run distro_bootcmd; run init_${boot}; run boot_rprocs; if test ${boot_fit} -eq 1; then run get_fit_${boot}; run get_overlaystring; run run_fit; else; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern; fi;"
|
|
CONFIG_LOGLEVEL=7
|
|
CONFIG_SPL_MAX_SIZE=0x58000
|
|
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
|
|
CONFIG_SPL_SYS_MALLOC=y
|
|
CONFIG_SPL_SYS_MALLOC_SIZE=0x800000
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x1400
|
|
CONFIG_SPL_DMA=y
|
|
CONFIG_SPL_ENV_SUPPORT=y
|
|
CONFIG_SPL_FS_LOAD_PAYLOAD_NAME="u-boot.img"
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_DM_MAILBOX=y
|
|
CONFIG_SPL_MTD=y
|
|
CONFIG_SPL_DM_SPI_FLASH=y
|
|
CONFIG_SPL_DM_RESET=y
|
|
CONFIG_SPL_POWER_DOMAIN=y
|
|
CONFIG_SPL_RAM_SUPPORT=y
|
|
# CONFIG_SPL_SPI_FLASH_TINY is not set
|
|
CONFIG_SPL_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPL_SPI_LOAD=y
|
|
CONFIG_SYS_SPI_U_BOOT_OFFS=0x280000
|
|
CONFIG_SPL_YMODEM_SUPPORT=y
|
|
CONFIG_CMD_ASKENV=y
|
|
CONFIG_CMD_DFU=y
|
|
CONFIG_CMD_GPT=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_PCI=y
|
|
CONFIG_CMD_REMOTEPROC=y
|
|
CONFIG_SPL_LOAD_FIT_APPLY_OVERLAY=y
|
|
CONFIG_CMD_USB=y
|
|
CONFIG_CMD_TIME=y
|
|
CONFIG_MTDIDS_DEFAULT="nor0=47040000.spi.0"
|
|
CONFIG_MTDPARTS_DEFAULT="mtdparts=47040000.spi.0:512k(ospi.tiboot3),2m(ospi.tispl),4m(ospi.u-boot),128k(ospi.env),128k(ospi.env.backup),1m(ospi.sysfw),-@8m(ospi.rootfs)"
|
|
CONFIG_CMD_UBI=y
|
|
CONFIG_MMC_SPEED_MODE_SET=y
|
|
# CONFIG_ISO_PARTITION is not set
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_SPL_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_IN_MMC=y
|
|
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_SYS_MMC_ENV_PART=1
|
|
CONFIG_NET_RANDOM_ETHADDR=y
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_SPL_SYSCON=y
|
|
CONFIG_SPL_OF_TRANSLATE=y
|
|
CONFIG_CLK=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_CLK_TI_SCI=y
|
|
CONFIG_DFU_MMC=y
|
|
CONFIG_DFU_RAM=y
|
|
CONFIG_DFU_SF=y
|
|
CONFIG_SYS_DFU_DATA_BUF_SIZE=0x20000
|
|
CONFIG_SYS_DFU_MAX_FILE_SIZE=0x800000
|
|
CONFIG_DMA_CHANNELS=y
|
|
CONFIG_TI_K3_NAVSS_UDMA=y
|
|
CONFIG_TI_SCI_PROTOCOL=y
|
|
CONFIG_DM_PCA953X=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
|
|
CONFIG_DM_I2C_GPIO=y
|
|
CONFIG_SYS_I2C_OMAP24XX=y
|
|
CONFIG_DM_MAILBOX=y
|
|
CONFIG_K3_SEC_PROXY=y
|
|
CONFIG_SUPPORT_EMMC_BOOT=y
|
|
CONFIG_MMC_IO_VOLTAGE=y
|
|
CONFIG_MMC_UHS_SUPPORT=y
|
|
CONFIG_MMC_HS200_SUPPORT=y
|
|
CONFIG_SPL_MMC_HS200_SUPPORT=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_MMC_SDHCI_ADMA=y
|
|
CONFIG_SPL_MMC_SDHCI_ADMA=y
|
|
CONFIG_MMC_SDHCI_AM654=y
|
|
CONFIG_MTD=y
|
|
CONFIG_DM_MTD=y
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_SFDP_SUPPORT=y
|
|
CONFIG_SPI_FLASH_STMICRO=y
|
|
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
|
|
CONFIG_SPI_FLASH_MTD=y
|
|
CONFIG_PHY_TI_DP83867=y
|
|
CONFIG_PHY_FIXED=y
|
|
CONFIG_E1000=y
|
|
CONFIG_CMD_E1000=y
|
|
CONFIG_TI_AM65_CPSW_NUSS=y
|
|
CONFIG_TI_ICSSG_PRUETH=y
|
|
CONFIG_PCI_KEYSTONE=y
|
|
CONFIG_PHY=y
|
|
CONFIG_SPL_PHY=y
|
|
CONFIG_AM654_PHY=y
|
|
CONFIG_OMAP_USB2_PHY=y
|
|
CONFIG_PINCTRL=y
|
|
# CONFIG_PINCTRL_GENERIC is not set
|
|
CONFIG_SPL_PINCTRL=y
|
|
# CONFIG_SPL_PINCTRL_GENERIC is not set
|
|
CONFIG_PINCTRL_SINGLE=y
|
|
CONFIG_POWER_DOMAIN=y
|
|
CONFIG_TI_SCI_POWER_DOMAIN=y
|
|
CONFIG_DM_REGULATOR=y
|
|
CONFIG_DM_REGULATOR_FIXED=y
|
|
CONFIG_DM_REGULATOR_GPIO=y
|
|
CONFIG_REMOTEPROC_TI_K3_R5F=y
|
|
CONFIG_REMOTEPROC_TI_PRU=y
|
|
CONFIG_RESET_TI_SCI=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SOC_DEVICE=y
|
|
CONFIG_SOC_DEVICE_TI_K3=y
|
|
CONFIG_SOC_TI=y
|
|
CONFIG_TI_PRUSS=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_CADENCE_QSPI=y
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_SPL_SYSRESET=y
|
|
CONFIG_SYSRESET_TI_SCI=y
|
|
CONFIG_USB=y
|
|
CONFIG_DM_USB_GADGET=y
|
|
CONFIG_SPL_DM_USB_GADGET=y
|
|
CONFIG_SPL_USB_HOST=y
|
|
CONFIG_USB_XHCI_HCD=y
|
|
CONFIG_USB_XHCI_DWC3=y
|
|
CONFIG_USB_DWC3=y
|
|
CONFIG_USB_DWC3_GENERIC=y
|
|
CONFIG_SPL_USB_DWC3_GENERIC=y
|
|
CONFIG_USB_KEYBOARD=y
|
|
CONFIG_SPL_USB_STORAGE=y
|
|
CONFIG_USB_GADGET=y
|
|
CONFIG_SPL_USB_GADGET=y
|
|
CONFIG_USB_GADGET_MANUFACTURER="Texas Instruments"
|
|
CONFIG_USB_GADGET_VENDOR_NUM=0x0451
|
|
CONFIG_USB_GADGET_PRODUCT_NUM=0x6162
|
|
CONFIG_USB_GADGET_DOWNLOAD=y
|
|
CONFIG_SPL_DFU=y
|
|
CONFIG_PHANDLE_CHECK_SEQ=y
|