signed_hdmi_imx8m.bin is already signed and has a IVT header. It should not
be put in u-boot-spl-mkimage.signed.bin. Move it to head of flash.bin
following NXP imx-mkimage. Keeping it in u-boot-spl-mkimage.signed.bin also
consumes a lot of TCM space which is not expected.
While moving it to head of flash.bin, other changes are required,
u-boot.itb is put at sector 768 per defconfig, so u-boot.itb binman
offset should be updated and it should be moved out from binman section.
Also binman symbol address are updated, so need to subtract u-boot-spl
image_pos + CONFIG_SPL_TEXT_BASE to find the correct location of ddr phy
firmware.
Because there is 1KB padding in HDMI firmware, use 32KB when burning
flash.bin to sd card.
Signed-off-by: Peng Fan <peng.fan@nxp.com>
This patch series adds support for ZFS listing and load to u-boot.
To Enable zfs ls and load commands, modify the board specific config file with
#define CONFIG_CMD_ZFS
Steps to test:
1. After applying the patch, zfs specific commands can be seen
in the boot loader prompt using
UBOOT #help
zfsload- load binary file from a ZFS file system
zfsls - list files in a directory (default /)
2. To list the files in zfs pool, device or partition, execute
zfsls <interface> <dev[:part]> [POOL/@/dir/file]
For example:
UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/
3. To read and load a file from an ZFS formatted partition to RAM, execute
zfsload <interface> <dev[:part]> [addr] [filename] [bytes]
For example:
UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage
References :
-- ZFS GRUB sources from Solaris GRUB-0.97
-- GRUB Bazaar repository
Jorgen Lundman <lundman at lundman.net> 2012.
5b6dba2924