mirror of
https://source.denx.de/u-boot/u-boot.git
synced 2026-06-13 15:03:58 +03:00
2ac8490412
A rather common kind of external watchdog circuit is one that is kept alive by toggling a gpio. Add a driver for handling such a watchdog. The corresponding linux driver apparently has support for some watchdog circuits which can be disabled by tri-stating the gpio, but I have never actually encountered such a chip in the wild; the whole point of adding an external watchdog is usually that it is not in any way under software control. For forward-compatibility, and to make DT describe the hardware, the current driver only supports devices that have the always-running property. I went a little back and forth on whether I should fail ->probe or only ->start, and ended up deciding ->start was the right place. The compatible string is probably a little odd as it has nothing to do with linux per se - however, I chose that to make .dts snippets reusable between device trees used with U-Boot and linux, and this is the (only) compatible string that linux' corresponding driver and DT binding accepts. I have asked whether one should/could add "wdt-gpio" to that binding, but the answer was no: https://lore.kernel.org/lkml/CAL_JsqKEGaFpiFV_oAtE+S_bnHkg4qry+bhx2EDs=NSbVf_giA@mail.gmail.com/ If someone feels strongly about this, I can certainly remove the "linux," part from the string - it probably wouldn't the only place where one can't reuse a DT snippet as-is between linux and U-Boot. Reviewed-by: Simon Glass <sjg@chromium.org> Reviewed-by: Stefan Roese <sr@denx.de> Signed-off-by: Rasmus Villemoes <rasmus.villemoes@prevas.dk>
This patch series adds support for ZFS listing and load to u-boot. To Enable zfs ls and load commands, modify the board specific config file with #define CONFIG_CMD_ZFS Steps to test: 1. After applying the patch, zfs specific commands can be seen in the boot loader prompt using UBOOT #help zfsload- load binary file from a ZFS file system zfsls - list files in a directory (default /) 2. To list the files in zfs pool, device or partition, execute zfsls <interface> <dev[:part]> [POOL/@/dir/file] For example: UBOOT #zfsls mmc 0:5 /rpool/@/usr/bin/ 3. To read and load a file from an ZFS formatted partition to RAM, execute zfsload <interface> <dev[:part]> [addr] [filename] [bytes] For example: UBOOT #zfsload mmc 2:2 0x30007fc0 /rpool/@/boot/uImage References : -- ZFS GRUB sources from Solaris GRUB-0.97 -- GRUB Bazaar repository Jorgen Lundman <lundman at lundman.net> 2012.