u-boot

mirror of https://source.denx.de/u-boot/u-boot.git synced 2026-06-13 15:03:58 +03:00

Files

Simon Glass 382bee57f1 env: Rename setenv() to env_set()

We are now using an env_ prefix for environment functions. Rename setenv()
for consistency. Also add function comments in common.h.

Suggested-by: Wolfgang Denk <wd@denx.de>
Signed-off-by: Simon Glass <sjg@chromium.org>

2017-08-16 08:22:18 -04:00

icorem6.c

env: Rename setenv() to env_set()

2017-08-16 08:22:18 -04:00

Kconfig

engicam: Generate single config file

2017-05-31 10:39:35 +02:00

MAINTAINERS

icorem6: Make SPL to pick suitable fdt

2017-05-18 11:23:31 +02:00

Makefile

…

README

imx6: icorem6: Rename engicam icorem6 defconfig files

2016-12-16 18:38:54 +01:00

README

How to use U-Boot on Engicam i.CoreM6 Solo/DualLite and Quad/Dual Starter Kit:
-----------------------------------------------------------------------------

$ make mrproper

- Configure U-Boot for Engicam i.CoreM6 Quad/Dual:
$ make imx6q_icore_mmc_defconfig

- Configure U-Boot for Engicam i.CoreM6 Solo/DualLite:
$ make imx6dl_icore_mmc_defconfig

- Build U-Boot
$ make

This will generate the SPL image called SPL and the u-boot-dtb.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot-dtb.img image into the micro SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

MMC Boot: JM3 Closed

- Connect the Serial cable between the Starter Kit and the PC for the console.
(J28 is the Linux Serial console connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.