Mirrors/avrdude
1
0
Fork 0
mirror of https://github.com/avrdudes/avrdude.git synced 2026-09-29 12:28:41 +03:00
Code Issues Packages Projects Releases Wiki Activity

Insert space between number and unit in docs

Browse Source
This commit is contained in:
stefanrueger
2025-06-18 01:16:14 +02:00
parent 5cf86d7d2d
commit 03760cabcb
1 changed files with 4 additions and 4 deletions
Download Patch File Download Diff File Expand all files Collapse all files

8
src/doc/avrdude.texi
View File

@@ -208,7 +208,7 @@ do not hold chip select down when a transfer is not occuring and thus
it cannot be used as the reset pin. A readily available level
translator should be used between the SPI bus/reset GPIO and the chip
to avoid potentially damaging the computer's SPI controller in the
event that the chip is running at 5V and the SPI runs at 3.3V. The
event that the chip is running at 5@w{ }V and the SPI runs at 3.3@w{ }V. The
GPIO chosen for reset can be configured in the avrdude configuration
file using the @code{reset} entry under the linuxspi programmer, or
directly in the port specification. An external pull-up resistor
@@ -238,7 +238,7 @@ A typical programming cable would then look like:
The @code{-P @var{port}} option defaults to
@code{/dev/spidev0.0:/dev/gpiochip0} for this programmer. And, mind the
3.3~V voltage level of the Raspberry Pi!
3.3@w{ }V voltage level of the Raspberry Pi!
@cindex Atmel STK500
@cindex Atmel JTAG ICE mkI
@@ -909,7 +909,7 @@ Posix systems (by now).
@cindex @code{--reconnect}
Opens the serial port at 1200 baud and immediately closes it, waits 400 ms
for each @code{-r} on the command line and then establishes communication
with the programmer. This is commonly known as a "1200bps touch", and is
with the programmer. This is commonly known as a "1200@w{ }bps touch", and is
used to trigger programming mode for certain boards like Arduino Leonardo,
Arduino Micro/Pro Micro and the Arduino Nano Every. Longer waits, and
therefore multiple @code{-r} options, are sometimes needed for slower, less
@@ -1894,7 +1894,7 @@ Connection to the PICkit2 programmer:
The PICkit2 programmer type accepts the following extended parameters:
@table @code
@item clockrate=@var{rate}
Sets the SPI clocking rate in Hz (default is 100kHz). Alternately the -B or -i options can be used to set the period.
Sets the SPI clocking rate in Hz (default is 100@w{ }kHz). Alternately the -B or -i options can be used to set the period.
@item timeout=@var{usb-transaction-timeout}
Sets the timeout for USB reads and writes in milliseconds (default is 1500 ms).
@end table